Skoči na glavni sadržaj

Izvorni znanstveni članak

The influence of the shape of grooves on the behavior of internal material discontinuities in continuous S355J2G3 steel strands during rolling

H. Dyja ; Faculty of Materials Processing Technology and Applied Physics, Czestochowa University of Technology, Poland
K. Sobczak ; Faculty of Materials Processing Technology and Applied Physics, Czestochowa University of Technology, Poland
A. Kawałek ; Faculty of Materials Processing Technology and Applied Physics, Czestochowa University of Technology, Poland


Puni tekst: engleski pdf 948 Kb

str. 501-504

preuzimanja: 567

citiraj


Sažetak

The article discusses problems related to the influence of rolling processes on the process of closing of internal discontinuities in continuous castings during rolling in shape grooves. Numerical modelling of the process of rolling 160 × 160 mm continuous S355J2G3 steel strands was carried out using the Forge 2008R software program. The experimental studies were conducted in a D150 laboratory rolling mill. Holes simulating material discontinuities were examined. In numerical and experimental studies, in steel samples after rolling in the third rolling stand, the defects were closing in 100 % on average. It was stated that the speed of closing of material discontinuities in feedstock is strongly influenced by the shape of the rolling groove.

Ključne riječi

rolling; continuous casting; defects; discontinuity; numerical simulation

Hrčak ID:

122173

URI

https://hrcak.srce.hr/122173

Datum izdavanja:

1.10.2014.

Posjeta: 1.007 *