Pregledni rad

https://doi.org/10.17559/TV-20150408152638

Impact of the hard facing technology and the filler metal on tribological characteristics of the hard faced forging dies

Dušan Arsić orcid.org/0000-0003-0326-0898 ; Faculty of Engineering, University of Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Vukić Lazić ; Faculty of Engineering, University of Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Ivan Samardžić ; Mechanical Engineering Faculty in Slavonski Brod, Josip Juraj Strossmayer University of Osijek, Trg Ivane Brlić-Mažuranić 2, 35000 Slavonski Brod, Croatia
Ružica Nikolić orcid.org/0000-0003-3042-8916 ; Faculty of Engineering, University of Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia and Research Center, University of Žilina Univerzitna 1, 010 26 Žilina, Slovakia
Srbislav Aleksandrović ; Faculty of Engineering, University of Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Milan Djordjević orcid.org/0000-0002-2591-8390 ; Faculty of Engineering, University of Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Branislav Hadzima ; Research Center, University of Žilina Univerzitna 1, 010 26 Žilina, Slovakia

Sažetak

The forging dies are parts, which are operating at elevated temperatures, while simultaneously subjected to variable loads that can be compressive - even impact and shear. Impact of the hard facing technology is very strong since varying of the hard facing parameters directly affects the output characteristics of the hard faced layers. The criterion for estimating that impact was based on results of performed tribological investigations. The tribological parameters that were monitored were the friction coefficient, the wear scar/trace width and the wear area of the hard faced layers, with the two different types of lubricants. Hard facing technology implied selection of the welding process, filler metals, preheating temperatures and other parameters of the hard facing process. The influence of the proposed hard facing technology was determined by monitoring hardness, microstructure and wear resistance of the executed joints after the hard facing and after tempering. The objective of this work was to establish the correlation between the selected hard facing technology, filler metals and applied heat treatment on mechanical and tribological characteristics of the executed hard faced layers.

Ključne riječi

forging dies; friction coefficient; hard facing; hardness; microstructure; wear resistance

Hrčak ID:

147307

URI

https://hrcak.srce.hr/147307

Datum izdavanja:

22.10.2015.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.889 *