Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20151028072528

The effect of the teeth profile shape on polymer gear pair properties

Jože Duhovnik ; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Damijan Zorko ; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Luka Sedej ; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia


Puni tekst: hrvatski pdf 2.037 Kb

str. 199-207

preuzimanja: 330

citiraj

Puni tekst: engleski pdf 2.037 Kb

str. 199-207

preuzimanja: 1.404

citiraj


Sažetak

The paper presents an extensive research on two different tooth-flank geometries, i.e. involute and S-gears. A significant difference between the two analyzed geometries was observed during the lifetime testing. The tests were conducted on special test equipment with an axis distance of 20 mm. The material used for the tested gears was POM for the driver gear and PA6 for the driven gear. The same sizes of driver and driven gears were used (m = 1 mm, z = 20). Gears of this size are particularly suitable for micro-gear transmissions. The tests were carried out using different rotational speeds and torques, between 0,8 N·m and 1,5 N·m. During testing the thermal state of the gears was measured with a thermal camera. The stress and deformation analyses of the tested gears were undertaken using numerical simulations employing the finite-element method.

Ključne riječi

failure; involute gears; polymer; S-gears; temperature

Hrčak ID:

153172

URI

https://hrcak.srce.hr/153172

Datum izdavanja:

19.2.2016.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.903 *