Skoči na glavni sadržaj

Izvorni znanstveni članak

An experimental modelling and numerical FE analysis of steel-strip ironing process

Dragan Adamovic ; Mechanical Engineering Faculty, University of Kragujevac, S. Janjić 6, RS-34000 Kragujevac, Serbia
Vesna Mandic orcid id orcid.org/0000-0003-1624-3536 ; Mechanical Engineering Faculty, University of Kragujevac, S. Janjić 6, RS-34000 Kragujevac, Serbia
Zoran Jurkovic orcid id orcid.org/0000-0002-7202-156X ; Department of Industrial Engineering and Management, Faculty of Engineering, University of Rijeka, Vukovarska 58, HR-51000 Rijeka, Croatia
Branko Grizelj ; Mechanical Engineering Faculty, University of Osijek, Trg Ivane Brlić Mažuranić 2, HR-35000 Slavonski Brod, Croatia
Milentije Stefanovic ; Mechanical Engineering Faculty, University of Kragujevac, S. Janjić 6, RS-34000 Kragujevac, Serbia
Tomislav Marinkovic ; The Higher Technical School of Professional Education, Aleksandra Medvedeva 20, RS-18000 Niš, Serbia
Srbislav Aleksandrovic ; Mechanical Engineering Faculty, University of Kragujevac, S. Janjić 6, RS-34000 Kragujevac, Serbia


Puni tekst: engleski pdf 662 Kb

str. 435-444

preuzimanja: 1.312

citiraj


Sažetak

This paper deals with analysis of steel strip ironing using experimental modelling and numerical FE simulation. Since both approaches are complementary to each other, numerous results were obtained that enable complete analysis of the processes within deformation zone. Device for modelling of strip ironing has been developed for experimental testing. Die cone angle, holding force, contact friction conditions on the die and the punch side were varied, due to easily replaceable working elements of the device. Friction coefficient values used in numerical FE simulations were determined based on measured values of forces on die and punch, as well as forming load on machine. Experimentally obtained results were confirmed by FE analysis that provided additional information about physics of the process itself within deformation zone. Presented research results point to coherent influences of process factors on tensile wall stress values, which represents key indicator for efficiency of forming, resulting in recommendations for efficient process management.

Ključne riječi

FE numerical simulation; modelling; steel strip ironing; wall stress

Hrčak ID:

62918

URI

https://hrcak.srce.hr/62918

Datum izdavanja:

31.12.2010.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.442 *