Transactions of FAMENA, Vol. 42 No. 3, 2018.
Izvorni znanstveni članak
https://doi.org/10.21278/TOF.42302
Tuning of Parameters for Robotic Contouring Based on the Evaluation of Force Deviation
Marko Švaco
; Department of Robotics and Production System Automation, Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Nikola Vitez
; Department of Robotics and Production System Automation, Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Bojan Šekoranja
; Department of Robotics and Production System Automation, Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Filip Šuligoj
; Department of Robotics and Production System Automation, Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Sažetak
The application of industrial robots with advanced sensor systems in unstructured environments is continuously becoming wider. A widely used type of advanced sensor systems is the force-torque sensor. Force-torque sensors are typically used for applications such as robot grinding, sanding, polishing, and deburring, where a constant force is exerted upon a workpiece. In this research, control parameters for exerting a constant force along a predefined path are evaluated in laboratory conditions. The experimental setup with the contouring force feedback is composed of a Fanuc LRMate six-degree-of-freedom industrial robot with an integrated force-torque sensor. Control parameters of the Contouring function within the Fanuc robot controller are tuned in four contouring experiments. The experiments conducted in this research are: i) flat beam, ii) flat beam with a rigid support, iii) wave shaped compliant plate, and iv) compliant flat plate. During the experiments, contouring parameters were altered in order to collect the feedback on the values of the force to be used for the evaluation of the force deviation. A fitness function for the evaluation of the force deviation and the tuning of the control parameters is presented. The fitness function enables a selection of initial control parameters which minimize the force deviation during the robot contouring process.
Ključne riječi
robotics; force-torque sensor; force sensing; contouring
Hrčak ID:
206942
URI
Datum izdavanja:
19.10.2018.
Posjeta: 1.618 *