Skoči na glavni sadržaj

Stručni rad

Structural Optimization of Corrugated Transverse Bulkheads Made of Stainless Steel

Jerolim Andrić orcid id orcid.org/0000-0001-5968-5807 ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture
Vedran Žanić ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture
Mate Grgić ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture


Puni tekst: engleski pdf 909 Kb

str. 18-27

preuzimanja: 2.095

citiraj


Sažetak

The article describes structural optimization applied to the minimum weight design of corrugated transverse bulkheads made of the duplex stainless steel. The study presented in this paper was carried out within the EU FP6 project IMPROVE as a sub-task of multi-level structural optimization that was performed with the aim of development of a new innovative design of chemical
tanker. This task can result in large benefi ts, because the unit price of duplex stainless steel is very high (5000 ÷ 6000 €/tons), and even the small savings of material can result in signifi cant cost savings. Corrugated transverse bulkhead structure of chemical tanker (CT) was developed, analyzed and optimized using partial 3D FEM model, with the objective to achieve improved and competitive design. Two types of corrugations: (1) horizontal-HC and (2) vertical-VC, were investigated, optimized and compared to enable rational selection of the preferred design. Final solutions, satisfying all structural constraints, resulted in 7% savings in structural mass. The total savings (fi ve duplex-steel made transverse bulkheads) of about 25 t can be expected with the cost benefi t of up to € 150 000.

Ključne riječi

structural optimization; corrugated bulkheads; FEM, chemical tanker

Hrčak ID:

50541

URI

https://hrcak.srce.hr/50541

Datum izdavanja:

31.3.2010.

Posjeta: 3.150 *