Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5599/jese.2012.0017

Silver ion recognition using potentiometric sensor based on recently synthesized isoquinoline-1,3-dione derivatives

Ajar Kamal ; Department of Chemistry, UGC-Centre for Advanced Studies, Guru Nanak Dev University, Amritsar-143005, India
Rajiv K. Puri ; Department of Chemistry, UGC-Centre for Advanced Studies, Guru Nanak Dev University, Amritsar-143005, India
Raghu Raj ; Department of Chemistry, UGC-Centre for Advanced Studies, Guru Nanak Dev University, Amritsar-143005, India
Vipan Kumar ; Department of Chemistry, UGC-Centre for Advanced Studies, Guru Nanak Dev University, Amritsar-143005, India
Rakesh K. Mahajan ; Department of Chemistry, UGC-Centre for Advanced Studies, Guru Nanak Dev University, Amritsar-143005, India


Puni tekst: engleski pdf 497 Kb

str. 143-154

preuzimanja: 839

citiraj


Sažetak

The four derivatives of isoquinoline-1,3-dione based on β-lactum (I-IV), have been explored as neutral ionophores for preparing poly(vinylchloride) based polymeric membrane electrodes (PME) selective to silver(I) ions. The addition of sodium tetraphenylborate (NaTPB) and dioctylsebacate (DOS) as a plasticizer was found to improve the performance of ion selective electrodes. The best performance was obtained with PME-1 based on ionophore I having composition: ionophore (9.2 mg), PVC (100.1 mg), DOS (201.1 mg) and NaTPB (1.5 mg) in 5 mL tetrahydrofuran. The electrode response was linear with Nernstian slope of 58.44 mV/decade in the concentration range of 1.0 x 10-1 M to 5.0 x 10-6 M and detection limit of 5.83 x 10-6 M. It performs satisfactorily over wide pH range of 1.0-5.5. The proposed sensor can be used over a period of more than three months without any significant drift in potential and shows good selectivity to silver(I) ion over a number of cations especially with no interference of mercury(II) ions. Sharp end point was obtained when the sensor was used as an indicator electrode for the potentiometric titration of silver(I) ions with chloride ions and therefore this electrode (PME-1) could be used for quantitative determination of silver(I) ion in synthetic water, silver foil and dental amalgam samples.

Ključne riječi

Isoquinoline-1,3-diones; silver(I) ion; Potentiometric sensor; Indicator electrode

Hrčak ID:

87012

URI

https://hrcak.srce.hr/87012

Datum izdavanja:

30.8.2012.

Posjeta: 1.259 *