Skoči na glavni sadržaj

Prethodno priopćenje

Experimental testing of quality of polymer parts produced by Laminated Object Manufacturing – LOM

Ana Pilipović orcid id orcid.org/0000-0003-1330-6458 ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Chair of Polymer Processing, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Pero Raos orcid id orcid.org/0000-0001-9263-1325 ; Josip Juraj Strossmayer University of Osijek, Mechanical Engineering Faculty, Chair for Machining and Polymer Processing, Trg Ivane Brlić Mažuranić 2, HR- 35000 Slavonski Brod, Croatia
Mladen Šercer ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Chair of Polymer Processing, Ivana Lučića 5, HR-10000 Zagreb, Croatia


Puni tekst: hrvatski pdf 472 Kb

str. 253-260

preuzimanja: 445

citiraj

Puni tekst: engleski pdf 472 Kb

str. 253-260

preuzimanja: 620

citiraj


Sažetak

Rapid prototyping procedures make it possible to produce relatively complicated geometries based on the computer 3D model of products in relatively short time. This requires that the respective product features have good quality, good mechanical properties, dimensional accuracy and precision. However, the number of available materials that can be used for prototyping is limited and their properties can differ significantly from the properties of the finished product. However, RP parts are not inexpensive and sometimes it is difficult to decide which procedure to use to manufacture them in order to obtain their maximal usability. The Laminated Object Manufacturing (LOM) procedure can be used to produce low cost polymeric products (from poly(vinyl chloride)) that have to meet certain mechanical properties, especially if they are used to perform functional tests. Past studies in LOM procedure have been carried out mainly with paper, and a few on metal. The paper deals with testing the influence of the position of products in the machine working area on the mechanical properties (tensile and flexural properties) of the product.

Ključne riječi

dimensional accuracy; flexural properties; LOM; roughness; tensile properties

Hrčak ID:

69591

URI

https://hrcak.srce.hr/69591

Datum izdavanja:

27.6.2011.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.824 *