Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5552/drind.2011.1113

Optimization of Cutting Process of Medium Density Fibreboards by the Abrasive Water-Jet

Štefan Barcík ; Fakultet šumarstva i drvne tehnologije Češkog sveučilišta bioloških znanosti u Pragu, Prag, Republika Češka
Monika Kvietková ; Fakultet šumarstva i drvne tehnologije Češkog sveučilišta bioloških znanosti u Pragu, Prag, Republika Češka
Richard Kminiak ; Fakultet za znanost o drvu i tehnologiju Tehničkog sveučilišta u Zvolenu, Zvolen, Republika Slovačka
Patrik Aláč ; Fakultet za znanost o drvu i tehnologiju Tehničkog sveučilišta u Zvolenu, Zvolen, Republika Slovačka


Puni tekst: engleski pdf 1.195 Kb

str. 263-268

preuzimanja: 934

citiraj


Sažetak

This paper deals with the process of MDF cutting by the abrasive water-jet (WJC) and shows how is kerf width infl uenced by process parameters. It presents the results of monitoring the kerf width related to technical and technological parameters, material parameters and cutting method. At the end of this paper, there is a detailed presentation of the possibilities of impacting kerf width by the change of the above mentioned parameters of the cutting process.

Ključne riječi

feed rate; abrasive flow; water-jet cutting; sample thickness

Hrčak ID:

75151

URI

https://hrcak.srce.hr/75151

Datum izdavanja:

22.12.2011.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.878 *