Izvorni znanstveni članak

Strain and strain-hardening analysis of formed parts produced by multi-pass metal spinning

Peter Šugár orcid.org/0000-0002-9499-5672 ; Slovak University of Technology, Faculty of Material Science and Technology, Institute of Production Engineering, J. Bottu 25, 917 24 Trnava, Slovakia
Jana Šugárová ; Slovak University of Technology, Faculty of Material Science and Technology, Institute of Production Engineering, J. Bottu 25, 917 24 Trnava, Slovakia
Peter Zemko ; Slovak University of Technology, Faculty of Material Science and Technology, Institute of Production Engineering, J. Bottu 25, 917 24 Trnava, Slovakia

Sažetak

The paper presents results of experimental study focused on the analysis of radial and hoop strain distributions and effect of strain-hardening of the surface layers of sheet metal hollow parts produced by multi-pass metal spinning. The thin sheets of 1 mm thickness, steel EN 10025-94 (ISO 630-80), were used for experimental study. The results of the study confirm minimal influence of the anisotropy of material on radial and hoop strain distributions and the relatively significant influence of the material anisotropy on the strain-hardening of the spun part's surface layers. It is found higher strain-hardening in the direction 90° refer to the rolling direction of the sheet compared to the direction 0°.

Ključne riječi

anisotropy; metal spinning; strain; strain-hardenining

Hrčak ID:

79166

URI

https://hrcak.srce.hr/79166

Datum izdavanja:

29.3.2012.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.509 *