Izvorni znanstveni članak

Polymerization of Composite Materials with Blue Superbright Light Emitting Diodes

Alen Knežević ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Zrinka Tarle ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Andrej Meniga ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Jozo Šutalo ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Goran Pichler ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Mira Ristić ; Zavod za dentalnu patologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska

Sažetak

Light source for photopolymerization is of great importance to ensure an adequate clinical composite filling. Halogen lamp is the commonly used unit for polymerization of composite materials in everyday clinical conditions. The development of new blue superbright light emitting diodes of 450 and 470 nm wavelengths represents an alternative to the halogen lamp. The purpose of this study was to compare the degree of conversion of three hybrid composite materials Tetric Ceram (Vivadent, Schaan, Liechtenstein), Pertac II (ESPE, Seefeld, Germany) and Valux Plus (3M Dental Products, St.Paul, MN) after illumination with the standard halogen lamp, Heliolux GTE (Vivadent, Liechtenstein) of600 mW/cm2 intensity and blue superbright light emitting diodes (Nichia, Japan) of minimal intensity of 9 mW/cm2. The results revealed only a slightly higher degree of conversion values in the case of polymerization, with even 66 times stronger halogen lamp.

Ključne riječi

degree of conversion; halogen curing unit; blue super-bright light emitting diodes

Hrčak ID:

97651

URI

https://hrcak.srce.hr/97651

Datum izdavanja:

15.9.1999.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.229 *