hrcak mascot   Srce   HID

Izvorni znanstveni članak

Investigation of surface roughness of composite fillings

Jozo Šutalo ; Department of Dental Pathology, School of Dentistry, University of Zagreb
Zoran Azinović ; Department of Dental Pathology, School of Dentistry, University of Zagreb
Marjan Tuđa ; Center for Research »Chromos« Zagreb
Ivana Ciglar ; Department of Dental Pathology, School of Dentistry, University of Zagreb

Puni tekst: engleski, pdf (11 MB) str. 11-11 preuzimanja: 400* citiraj
APA 6th Edition
Šutalo, J., Azinović, Z., Tuđa, M. i Ciglar, I. (1988). Investigation of surface roughness of composite fillings. Acta stomatologica Croatica, 22 (1), 11-11. Preuzeto s https://hrcak.srce.hr/101771
MLA 8th Edition
Šutalo, Jozo, et al. "Investigation of surface roughness of composite fillings." Acta stomatologica Croatica, vol. 22, br. 1, 1988, str. 11-11. https://hrcak.srce.hr/101771. Citirano 02.03.2021.
Chicago 17th Edition
Šutalo, Jozo, Zoran Azinović, Marjan Tuđa i Ivana Ciglar. "Investigation of surface roughness of composite fillings." Acta stomatologica Croatica 22, br. 1 (1988): 11-11. https://hrcak.srce.hr/101771
Harvard
Šutalo, J., et al. (1988). 'Investigation of surface roughness of composite fillings', Acta stomatologica Croatica, 22(1), str. 11-11. Preuzeto s: https://hrcak.srce.hr/101771 (Datum pristupa: 02.03.2021.)
Vancouver
Šutalo J, Azinović Z, Tuđa M, Ciglar I. Investigation of surface roughness of composite fillings. Acta stomatologica Croatica [Internet]. 1988 [pristupljeno 02.03.2021.];22(1):11-11. Dostupno na: https://hrcak.srce.hr/101771
IEEE
J. Šutalo, Z. Azinović, M. Tuđa i I. Ciglar, "Investigation of surface roughness of composite fillings", Acta stomatologica Croatica, vol.22, br. 1, str. 11-11, 1988. [Online]. Dostupno na: https://hrcak.srce.hr/101771. [Citirano: 02.03.2021.]

Sažetak
Degree of surface roughness of five different composite materials
for cavity fillings (Adaptic, Aura fill, Command, Heliosit and Silux) was
assessed after mechanical finishing. Various grinders (diamond and carbide burs, and soflex disks) were used in polishing the composite filling surfaces. Polishing was carried out 10 minutes and 14 days after the material polymerization. The ground surface was then observed by a scanning electron microscope and the surface roughness expressed in microm. Better surface polish and lower degree of roughness were observed when polishing was performed 14 days after polymerization. Best results were obtained in specimens polished by soflex disks and diamond burs.

Ključne riječi
roughness; composite

Hrčak ID: 101771

URI
https://hrcak.srce.hr/101771

[hrvatski]

Posjeta: 606 *