Tehnički vjesnik, Vol. 21 No. 4, 2014.
Izvorni znanstveni članak
Experimental investigation of high speed milling of aluminium alloy
Julia Hricova
; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Studentska 26, 96053 Zvolen, Slovakia
Martin Kovac
; Faculty of Material Science and Technology in Trnava, Slovak University of Technology in Bratislava, Bottova 25, 917 24 Trnava, Slovakia
Peter Sugar
orcid.org/0000-0002-9499-5672
; Faculty of Material Science and Technology in Trnava, Slovak University of Technology in Bratislava, Bottova 25, 917 24 Trnava, Slovakia
Sažetak
The customer´s growing demand for higher quality products has forced manufacturing industry to continuously progress in quality control and machining technologies. One of the fundamental metal cutting processes is milling. The aim of this study is to investigate optimum cutting parameters of AlMgSi alloy (EN-AW 6060), which is one of the most commonly used aluminium alloys, using uncoated cemented carbide end mills. The influence of tool geometry (helix angle) and cutting conditions (cutting velocity, and feed rate) on the surface finish produced during high speed milling of aluminium alloy have been investigated. The significance of the parameters on surface roughness has been established with analysis of variance (ANOVA). The cutting parameters regarding surface roughness performance indexes are analysed, and the findings are discussed and evaluated.
Ključne riječi
aluminium alloy; end mill; high speed milling; surface roughness
Hrčak ID:
126072
URI
Datum izdavanja:
15.8.2014.
Posjeta: 2.967 *