Tehnički vjesnik, Vol. 21 No. 6, 2014.
Izvorni znanstveni članak
Comparative model analysis of two types of clamping elements in dynamic conditions
Petar M. Todorovic
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Borut Buchmeister
orcid.org/0000-0003-3549-9596
; University of Maribor, Faculty of Mechanical Engineering, Smetanova 17, 2000 Maribor, Slovenia
Marko J. Djapan
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Djordje Vukelic
orcid.org/0000-0003-2420-6778
; University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Marko D. Milosevic
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Branko Tadic
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Milan M. Radenkovic
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Sažetak
This paper studies the compliance of the fixture-workpiece system. Workpiece clamping case with two types of clamping elements is considered. The first type of clamping element is standard, with flat top, while the second one is specially designed, with round cutting insert. Analyzed was the case of workpiece clamping using small forces, whereby the deformations in the workpiece/clamping element interface are predominantly on the order of magnitude of roughness height. A comparative analysis of dynamic behaviour of both types of clamping elements is also presented. In comparison with its standard counterpart, the specially designed clamping element with round cutting insert has superior clamping performance regarding both tangential load capacity and compliance.
Ključne riječi
clamping; compliance; fixture; roughness
Hrčak ID:
131214
URI
Datum izdavanja:
21.12.2014.
Posjeta: 1.695 *