Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20140905132417

Effect of anti-wear additive on cutting tool and surface layer of workpiece state under MQCL conditions

Radoslaw Maruda ; University of Zielona Gora, Faculty of Mechanical Engineering, ul. Licealna 9, 65-417 Zielona Góra, Poland
Stanislaw Legutko orcid id orcid.org/0000-0001-8973-5035 ; Faculty of Mechanical Engineering and Management, Poznan University of Technology, 3 Piotrowo Street, 60-965 Poznan, Poland
Grzegorz Krolczyk ; Opole University of Technology, 76 Prószkowska Street, 45-758 Opole, Poland
Czeslaw Lukianowicz orcid id orcid.org/0000-0001-8885-1317 ; Koszalin University of Technology, Faculty of Mechanical Engineering, ul. Racławicka 15-17, 75-620 Koszalin, Poland
Antun Stoić ; Mechanical Engineering Faculty in Slavonski Brod, J. J. Strossmayer University of Osijek Trg Ivane Brlić Mažuranić 2 HR-35 000 Slavonski Brod, Croatia


Puni tekst: hrvatski pdf 1.786 Kb

str. 1219-1223

preuzimanja: 410

citiraj

Puni tekst: engleski pdf 1.786 Kb

str. 1219-1223

preuzimanja: 610

citiraj


Sažetak

The work presents the results of investigation of the influence of anti-wear additive Crodafos EHA-LQ-(MH) added to the emulsion mist on the condition of machined surface of 1.4310 stainless steel after turning. The investigation included the comparison of the following cutting conditions: dry machining, cooling by the MQCL method and cooling by the MQCL method with Crodafos EHA-LQ-(MH). In the paper, the influence of the Anti-Wear (AW) additive on the roughness parameter Ra of the machined surface for various cutting speeds, vc, and mass flow of the emulsion E has been shown. It was found that the MQCL+AW method decreases the Ra parameter values by 14 % to 35 % in comparison with dry cutting and by 17 % in comparison with MQCL method.The machined material and the rake face of the cutting wedge have been subjected to micro X-ray spectroanalysis. Chemical analysis of the cutting wedge and the surface layer of the machined material has been performed. The results show that water dropletts in MQCL method are very good transport facility for active compounds of AW additive that consequently form the dry-film lubricant on the machined surface.

Ključne riječi

Anti-Wear additives; MQCL; stainless steel; surface roughness; turning

Hrčak ID:

147291

URI

https://hrcak.srce.hr/147291

Datum izdavanja:

22.10.2015.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.834 *