Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20141201225004

Prediction of technological parameters of sheet metal bending in two stages using feed forward neural network

Jernej Senveter orcid id orcid.org/0000-0002-5581-7726 ; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Joze Balic ; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Mirko Ficko ; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Simon Klancnik ; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia


Puni tekst: hrvatski pdf 900 Kb

str. 1155-1161

preuzimanja: 739

citiraj

Puni tekst: engleski pdf 900 Kb

str. 1155-1161

preuzimanja: 315

citiraj


Sažetak

This paper describes sheet metal bending in two stages as well as predicting and testing of the final bend angle by means of a feed-forward neural network. The primary objective was to research the technological parameters of bending sheet metal in two stages and to develop an intelligent method that would enable the predicting of those technological parameters. The process of bending sheet metal in two stages is presented by demonstrating the various technological parameters and the test tool used to carry out tests and measurements. The results of the tests and measurements were of decisive guidance in the evaluation of individual technological parameters. Developed method for prediction of the final bend angle is based on a feed-forward neural network that receives signals at the input level. These signals then travel through the hidden level to the output level, where the responses to input signals are received. The input to the neural network is composed of data that affect the selection of the final bend angle. Only five different inputs are used for the total neural network. By choosing the desired final bend angle by means of the trained neural network, bending sheet metal in two stages is optimised and made more efficient.

Ključne riječi

bending in two stages; intelligent system; neural network; prediction of the final bend angle

Hrčak ID:

163794

URI

https://hrcak.srce.hr/163794

Datum izdavanja:

16.8.2016.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.950 *