Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5552/drind.2016.1531

Surface Roughness and Wettability Variation: The effect of Cutting Distance during Milling of Pinus Radiata Wood

Aldo Rolleri ; Laboratorij za šumske proizvode, Fakultet znanosti o šumama i prirodnim resursima, Južno sveučilište u Čileu, Valdivia, Čile
Francisco Burgos ; Laboratorij za šumske proizvode, Fakultet znanosti o šumama i prirodnim resursima, Južno sveučilište u Čileu, Valdivia, Čile
Alfredo Aguilera ; Laboratorij za šumske proizvode, Fakultet znanosti o šumama i prirodnim resursima, Južno sveučilište u Čileu, Valdivia, Čile


Puni tekst: engleski pdf 681 Kb

str. 223-228

preuzimanja: 765

citiraj


Sažetak

The variation of the machined surface properties is usually described in terms of changes in cutting parameters. However, the effect of the cutting distance should be considered, as it further shows the influence of the cutting tool wear. In order to assess the effect of the cutting distance on roughness and wettability of Pinus radiata wood surfaces, three conditions of feed speed and cutting speed were applied on cutting distance of 0 to 10000 meters. This study describes the effect of machining parameters on the behavior of roughness and wettability through the cutting distance, and the interaction of both surface properties is also discussed. The variation of surface roughness in function of the cutting distance is not directly related to variations in the surface wettability. It was, therefore, concluded that is was not reliable to consider only the surface roughness to explain the wetting behavior of a heterogeneous surface such as wood.

Ključne riječi

cutting distance; roughness; wettability; contact angle; wood; milling

Hrčak ID:

166745

URI

https://hrcak.srce.hr/166745

Datum izdavanja:

30.9.2016.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.603 *