Izvorni znanstveni članak
https://doi.org/10.17559/TV-20140203083223
Detection of grinding burn through the high and low frequency Barkhausen noise
Anna Mičietová
; Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 010 26 Žilina, Slovak Republic
Miroslav Neslušan
; Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 010 26 Žilina, Slovak Republic
Robert Čep
orcid.org/0000-0001-9610-4215
; Faculty of Mechanical Engineering, Technical University of Ostrava, 17. listopadu 15/2172, 708 33, Czech Republic
Vladislav Ochodek
; Faculty of Mechanical Engineering, Technical University of Ostrava, 17. listopadu 15/2172, 708 33, Czech Republic
Branislav Mičieta
; Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 010 26 Žilina, Slovak Republic
Marek Pagáč
; Faculty of Mechanical Engineering, Technical University of Ostrava, 17. listopadu 15/2172, 708 33, Czech Republic
Sažetak
This paper deals with detection of surface damage after grinding through non-destructive micro magnetic technique based on Barkhausen noise. Paper compares the high and low frequency techniques and their sensitivity to detect surface burn and thickness of heat affected zone. The results of investigation indicate that the low frequency technique can more clearly detect surface burn than the high frequency technique due to relatively high thickness of heat affected zones obtained after grinding operations. The paper also discusses additional aspects of micro magnetic testing as a multi parametric technique where such parameters as Peak Position of Barkhausen noise loop correlate with the thermal load of machined surface. The paper also reports about corresponding structure transformations and associated stress state beneath the surface.
Ključne riječi
Barkhausen noise; detection; grinding; surface burn
Hrčak ID:
181243
URI
Datum izdavanja:
10.5.2017.
Posjeta: 1.649 *