Skoči na glavni sadržaj

Acta stomatologica Croatica : International journal of oral sciences and dental medicine, Vol. 53 No. 1, 2019.

Izvorni znanstveni članak

https://doi.org/10.15644/asc53/1/4

Effects of Curing Modes on the Microhardness of Resin-Modified Glass Ionomer Cements

Jelena Spajić ; Dom zdravlja, Runjaninova 4, Zagreb, Hrvatska
Matej Par ; Zavod za endodonciju i restaurativnu stomatologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Ognjen Milat ; Institut za fiziku, Zagreb, Hrvatska
Nazif Demoli ; Institut za fiziku, Zagreb, Hrvatska
Ruža Bjelovučić ; Privatna ordinacija dentalne medicine, Sisak, Hrvatska
Katica Prskalo ; Zavod za endodonciju i restaurativnu stomatologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska

Puni tekst: hrvatski pdf 322 Kb

str. 37-46

preuzimanja: 438

citiraj

Puni tekst: engleski pdf 322 Kb

str. 37-46

preuzimanja: 1.522

citiraj

Sažetak

Objective: This study evaluated the effects of curing modes on surface microhardness of visible lightcured resin-modified glass ionomer cements (VLC RMGIC) and a giomer after different storage periods
in comparison to auto-cured resin-modified glass ionomer cements (AC RMGIC). Materials and Methods: The following materials were used: VLC RMIC: Fuji II LC Improved, Photac Fil Quick Aplicap, AC RMGIC: Fuji Plus, Fuji VIII and Giomer: Beautifil II. The measurements of microhardness were performed using a Vickers test (100 g loads were applied for 10 s) in the following time intervals: immediately after the recommended cure and after 1, 7 and 14 days of immersion in distilled water. Five samples (d=4 mm, h=2 mm) were prepared for each combination of curing mode and tested material. Results: After 14 days, an improvement of microhardness was evident in all tested materials. The full factorial ANOVA identified a highly significant (p<0.001) effect of the factors “material”, “time” and “curing mode (“low”, “soft“, „high”) for the light-cured materials Beautifil II, Fuji II LC and Photac Fil Quick. There was a statistically significant difference in the microhardness between different material types (Beautifil II>Fuji II LC>Photac Fil Quick>Fuji Plus>Fuji VIII) and curing modes (low materials.

Ključne riječi

Dental Materials; Light-Curing of Dental Adhesives; Glass Ionomer Cements; Hardness Tests

Hrčak ID:

218000

URI

https://hrcak.srce.hr/218000

Datum izdavanja:

19.3.2019.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.959 *