Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5552/crojfe.2019.678

Biomass Yield and Fuel Properties of Different Poplar SRC Clones

Dinko Vusić orcid id orcid.org/0000-0001-5594-1092 ; University of Zagreb Faculty of Forestry Svetošimunska cesta 25 10000 Zagreb CROATIA
Davorin Kajba ; University of Zagreb Faculty of Forestry Svetošimunska cesta 25 10000 Zagreb CROATIA
Ivan Andrić ; Andrije Hebranga 7 43500 Daruvar CROATIA
Ivan Gavran ; Hrvatskog proljeća I. odv. 6 44440 Dvor CROATIA
Tin Tomić ; Stjepana Radića 44 35425 Davor CROATIA
Ivana Plišo Vusić ; Banski vinogradi 26b 10090 Zagreb CROATIA
Željko Zečić ; University of Zagreb Faculty of Forestry Svetošimunska cesta 25 10000 Zagreb CROATIA


Puni tekst: engleski pdf 943 Kb

str. 231-238

preuzimanja: 328

citiraj


Sažetak

The goal of the research was to determine the biomass yield and fuel properties of ten different poplar clones. The research was conducted in an experimental plot established in Forest Administration Osijek, Forest Office Darda, in the spring of 2014. The layout of the plot consisted of three repetitions per clone with 40 plants per repetition in spacing 3x1 m. Based on the DBH distribution, in the early spring of 2018, one sample tree of an average DBH per repetition was selected, thus forming a sample of 30 trees.
Average survival rate of the investigated trees after four vegetation periods was 74.54 ±13.85% ranging from 52.08% (Koreana) to 91.67% (SV885 and SV490). Average DBH of the sample trees was 8.2 ±1.9 cm, height 9.3 ±1.8 m and root collar diameter 10.7 ±1.9 cm. Moisture content in fresh state (just after the felling) ranged from 51.6% (Hybride 275) to 55.9% (SV885). Bark content averaged 18.4%, from 15.4% (Baldo) to 21.1% (V 609). Average nominal density of the sampled trees amounted to 383.5 ±35.9 kg/m3. Bark ash content was on average ten times higher (6.44 ±0.65%) than wood ash content (0.64 ±0.07%) resulting in average ash content of 1.7 ±0.1% (taking the bark content into account).
The clone SV490 showed the highest biomass yield with 15.8 t/ha/year, while the lowest biomass yield was recorded for the clone Hybride 275 with 2.8 t/ha/year.
High inter-clonal productivity variation stresses the importance of selection work to find the most appropriate clones with the highest productivity potential for the given area where the poplar SRC plantations are to be established.
Due to high initial moisture content, if direct chipping harvesting systems are preferred, wood chips could be efficiently used in CHP (Combined Heat and Power) plants that operate on the principle of biomass gasification (where a gasifier is coupled to a gas engine to produce electric power and heat). In several CHP gasification plants operating in Croatia, wood chips with high initial moisture content (from traditional poplar plantations) are used as a feedstock that has to be pre-dried using the surplus heat. In this respect SRC poplar wood chips could make an ideal feedstock supplement.

Ključne riječi

biomass; moisture content; nominal density; bark content; ash content

Hrčak ID:

228237

URI

https://hrcak.srce.hr/228237

Datum izdavanja:

1.8.2019.

Posjeta: 839 *