Izvorni znanstveni članak

https://doi.org/10.31803/tg-20200504092314

Tolerance Analysis of Mechanical Parts

Živko Kondić ; University North, University Center Varaždin, Jurja Križanića 31b, 42 000 Varaždin, Croatia
Đuro Tunjić orcid.org/0000-0002-9397-4108 ; TUV Croatia d.o.o. Bani 110, 10 010 Zagreb, Croatia
Leon Maglić ; University of Slavonski Brod, Mechanical Engineering Faculty, Trg Ivane Brlić Mažuranić 2, 35 000 Slavonski Brod, Croatia
Amalija Horvatić Novak orcid.org/0000-0003-4665-255X ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10 000 Zagreb, Croatia

Sažetak

The determination of tolerances has a huge impact on the price and quality of products. The objective of tolerance analysis is to provide the widest possible tolerance range of parts, without disturbing the functionality of the assembly. Tolerance analysis should be performed during the design process because then there is still the possibility for change. For the purpose of carrying out the analysis, three methods will be used: Worst Case method, Root Sum Square method and Monte Carlo Simulation. Methods are explained through simple examples and applied on the one-way clutch.

Ključne riječi

Monte Carlo simulation; one-way clutch; Root Sum Square; tolerance analysis; Worst Case analysis

Hrčak ID:

243660

URI

https://hrcak.srce.hr/243660

Datum izdavanja:

14.9.2020.

Posjeta: 1.505 *