Tehnički vjesnik, Vol. 28 No. 2, 2021.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20200108155228
The Analysis of the Residual Stress Evolution during Cycling Oxidation of the Ni-base Superalloys at High Temperature
Wojciech J. Nowak*
orcid.org/0000-0002-5285-4900
; Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Powstanców Warszawy 8, 35-959 Rzeszów, Poland
Kamil Ochał
; Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Powstanców Warszawy 8, 35-959 Rzeszów, Poland
Ryszard Filip
; Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Powstanców Warszawy 8, 35-959 Rzeszów, Poland
Bartek Wierzba
; Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Powstanców Warszawy 8, 35-959 Rzeszów, Poland
Sažetak
The lifetime of the elements made of Ni-base superalloys can be strongly increased by introducing compressive stresses. Such stresses increase the resistance of cracks nucleation and formation during cyclic loads. Therefore, it is important to know how the stresses in the cold rolled Ni-based superalloys evolve during the service. Ni-base superalloys are dedicated to the usage at elevated temperature. However, exposing the Ni-based superalloys to high temperature results in their oxidation. So far, not a single work on the studies of the residual stress evolution in the Ni-based superalloys during cycling oxidation at high temperature was performed. Thus in the present study the residual stress in the materials in the as-received conditions and the changes in the residual stresses during cycling oxidation of IN 625 and IN 718 at 1273 K in air was investigated and described. The obtained results showed differences in the residual stresses level measured for investigated alloys. It was also found that thermal cycling of studied alloys influences the residual stresses. However even after the end of the test, the measured residual stresses were still compressive. Slightly different oxidation resistance was found for the studied alloys, namely, IN 718 was found to be more prone to oxide scale spallation. The latter was correlated with different alloy chemical composition, which results in formation of δ - phase in IN 718. The dissolution of δ - phase during high temperature exposure resulted in formation of sub-scale enriched with Nb and Ti in the near oxide scale/substrate interface. The latter was claimed to have a negative effect on oxide scale adherence.
Ključne riječi
cyclic oxidation test; Inconel 625; Inconel 718; microstructure changes; Ni-base superalloys; oxide scale; residual stress
Hrčak ID:
255824
URI
Datum izdavanja:
17.4.2021.
Posjeta: 838 *