Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.31534/engmod.2021.2.ri.01m

Calibration of an Existing Creep Model for Analysis of Aluminium Members Exposed to Constant Temperature

Marko Goreta orcid id orcid.org/0000-0001-7645-1623 ; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA
Neno Torić orcid id orcid.org/0000-0003-2282-8362 ; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA
Ivica Boko orcid id orcid.org/0000-0003-2282-8362 ; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA


Puni tekst: engleski pdf 650 Kb

str. 1-15

preuzimanja: 657

citiraj


Sažetak

The paper presents the development of a creep model applicable for the analysis of aluminium members exposed to a constant temperature. The model is intended as a base for defining a creep model in a transient heating regime. The behaviour of aluminium members exposed to the transient heating regime is a relatively unexplored topic in the scientific community. There is a need for defining an advanced creep model for aluminium, which should cover any heating regime to model the influence of creep on members exposed to fire. A comparison of results between the existing experimental data and the built-in creep models from commercial software ANSYS 16.2 for specific temperature and stress levels is provided. The experimental data used was extracted from previous tests carried out on coupons of aluminium alloy EN 6082 AW T6 and fitted in the aforementioned ANSYS models which serve as a base for defining the representative advanced creep model.

Ključne riječi

aluminium; creep; fire; column; coupon; tests; EN 6082 AW T6; ANSYS 16.2

Hrčak ID:

259694

URI

https://hrcak.srce.hr/259694

Datum izdavanja:

25.11.2021.

Posjeta: 1.167 *