Izvorni znanstveni članak

Influence of casting rate on the mixing process of steel in non-symmetric tundish

T. Merder orcid.org/0000-0002-3766-6784 ; Silesian University of Technology, Faculty of Material Science, Katowice, Poland
J. Pieprzyca orcid.org/0000-0002-7615-6082 ; Silesian University of Technology, Faculty of Material Science, Katowice, Poland

Sažetak

The article presents the results of research aimed at determining the nature of changes in the mixing of liquid steel in asymmetrical tundish due to the increase in casting speed and the possibility of limiting the use of Flow Control Devices (FCD). The tests were carried out on the water model of the Continuous Steel Casting (CSC) device equipped with the tundish model. Four variants of casting speed were analyzed. The analysis of the obtained results was divided into two stages: qualitative analysis of flow and mixing (visualization process) and quantitative analysis of flow and mixing (by analysis of mixing curves - Residence Time Distribution (RTD) type F).

Ključne riječi

tundish; steel flow; mixing time; casting rate; water model

Hrčak ID:

265903

URI

https://hrcak.srce.hr/265903

Datum izdavanja:

1.4.2022.

Posjeta: 778 *