Skoči na glavni sadržaj

Prethodno priopćenje

CREATING A PALETTE BOW TIPPER WITH TECHNOLOGY OF DEFORMATION

Dejan Deželjin ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska
Branimir Barišić ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska
Tibor Szalay ; Budampest University of Technology and Economics Department of Manufacturing Science and Technology
Marko Kršulja ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska


Puni tekst: hrvatski pdf 1.113 Kb

str. 71-79

preuzimanja: 1.394

citiraj

Puni tekst: engleski pdf 1.113 Kb

str. 71-79

preuzimanja: 1.293

citiraj


Sažetak

Work shows the entire process of palette bow tipper construction. The process of modeling, preparation and the process of production are described. Parts were prepared for processing on machines by the use of CAD/CAM software following the rules of deformation technology. With the demonstrated procedure, the production process was optimized, and the production process was accelerated and controlled in all production steps. Modeling and simulation were performed by the use of the software SolidWorks. Then the model was separated into sections that were transported in the software ToPs 300, where the optimum use of sheet metal panels was planned and carried out. In this work, the basic rules of modeling and some technological solutions during the execution of the bow tipper palette are demonstrated.

Ključne riječi

sheet metal forming; modelling; bending; punching

Hrčak ID:

39445

URI

https://hrcak.srce.hr/39445

Datum izdavanja:

22.7.2009.

Podaci na drugim jezicima: hrvatski

Posjeta: 3.768 *