Skoči na glavni sadržaj

Prethodno priopćenje

DETERMINATION OF TECHNOLOGICAL PARAMETERS LIMIT VALUES ON PLANNED EXPERIMENT, PROPOSAL FOR FOLLOWING PRODUCTS FROM THERMOPLASTICS QUALITATIVE PARAMETERS

Jozef DOBRÁNSKY ; Technical University in Košice, Faculty of Manufacturing Technologies, Prešov, Slovak Republic
Emil RAGAN ; Technical University in Košice, Faculty of Manufacturing Technologies, Prešov, Slovak Republic
Naqib DANESHJO ; Technical University in Košice, Faculty of Mechanical Engineering, Prešov, Slovak Republic


Puni tekst: engleski pdf 1.034 Kb

str. 45-51

preuzimanja: 507

citiraj


Sažetak

he contribution concerns the determination of the technological parameters limit values necessary for the planned experiment proposal, where the influence of single technological parameters will be observed. Technological parameters in mutual interaction influence the resulting quality of thermoplastics products produced through the technology of injection molding. The three distinct technological parameters that were used mainly in mutual interaction influencing qualitative characteristics of the products in manufacturing process were chosen from the technological parameters set. During experimental measurement, the value of one technological parameter was always changed. At every change, experimental samples were produced and then were measured and evaluated.

Ključne riječi

experiment; quality; technological parameter; product

Hrčak ID:

46002

URI

https://hrcak.srce.hr/46002

Datum izdavanja:

24.12.2009.

Posjeta: 949 *