Skoči na glavni sadržaj

Prethodno priopćenje

Impact of abrasive mass flow rate when penetrating into a material on its vibration

Pavol Hreha ; Faculty of Manufacturing Technologies of Technical University of Košice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovak Republic
Sergej Hloch ; Faculty of Manufacturing Technologies of Technical University of Košice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovak Republic
Jan Valíček ; Faculty of Mining and Geology, VŠB - Technical University of Ostrava, 17 Listopadu, 708 33 Ostrava-Poruba, Czech Republic
Katarína Monková ; Faculty of Manufacturing Technologies of Technical University of Košice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovak Republic
Peter Monka ; Faculty of Manufacturing Technologies of Technical University of Košice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovak Republic
Marta Harničárová ; Faculty of Manufacturing Technologies of Technical University of Košice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovak Republic
Martin Fusek ; Faculty of Mechanical Engineering, VŠB - Technical University of Ostrava, 17 Listopadu, 708 33 Ostrava-Poruba, Czech Republic
Pejo Konjatić ; Mechanical Enginnering Faculty in Slavonski Brod, J. J. Strossmayer University of Osijek, Trg Ivane Brlić-Mažuranić 2, HR-35000 Slavonski Brod, Croatia


Puni tekst: engleski pdf 599 Kb

str. 475-480

preuzimanja: 628

citiraj


Sažetak

The article deals with the impact of mass flow rate of abrasive in a water jet when penetrating into a material by using the vibration analysis. The vibrations of material were recorded by sensors placed on the experimental material. Values that were studied were amplitude and FFT (Fast Fourier Transform) spectrum of signal. The stainless steel AISI309 was used as the experimental material. Data recorded during the cutting process of the AWJ cutting were analysed by the LabVIEW programming environment. The paper outlines the course of the recorded data and the FFT spectrum of this signal. Presented here is only a part of the basic research focused on the application of vibrations as a feedback for on-line control of abrasive water jet.

Ključne riječi

abrasive water jet; abrasive mass flow rate; penetration into material; vibration analysis

Hrčak ID:

62922

URI

https://hrcak.srce.hr/62922

Datum izdavanja:

31.12.2010.

Podaci na drugim jezicima: hrvatski

Posjeta: 1.389 *