hrcak mascot   Srce   HID

Izvorni znanstveni članak

Analysis of Factors that Influence Micro-Resistance Measuring

Eraldo BANOVAC ; Mechanical Engineering Faculty Josip Juraj Strossmayer University of Osijek,Slavonski Brod, Croatia
Dražan KOZAK

Puni tekst: engleski, pdf (2 MB) str. 261-270 preuzimanja: 403* citiraj
APA 6th Edition
BANOVAC, E. i KOZAK, D. (2010). Analysis of Factors that Influence Micro-Resistance Measuring. Strojarstvo, 52 (3), 261-270. Preuzeto s https://hrcak.srce.hr/64343
MLA 8th Edition
BANOVAC, Eraldo i Dražan KOZAK. "Analysis of Factors that Influence Micro-Resistance Measuring." Strojarstvo, vol. 52, br. 3, 2010, str. 261-270. https://hrcak.srce.hr/64343. Citirano 14.11.2019.
Chicago 17th Edition
BANOVAC, Eraldo i Dražan KOZAK. "Analysis of Factors that Influence Micro-Resistance Measuring." Strojarstvo 52, br. 3 (2010): 261-270. https://hrcak.srce.hr/64343
Harvard
BANOVAC, E., i KOZAK, D. (2010). 'Analysis of Factors that Influence Micro-Resistance Measuring', Strojarstvo, 52(3), str. 261-270. Preuzeto s: https://hrcak.srce.hr/64343 (Datum pristupa: 14.11.2019.)
Vancouver
BANOVAC E, KOZAK D. Analysis of Factors that Influence Micro-Resistance Measuring. Strojarstvo [Internet]. 2010 [pristupljeno 14.11.2019.];52(3):261-270. Dostupno na: https://hrcak.srce.hr/64343
IEEE
E. BANOVAC i D. KOZAK, "Analysis of Factors that Influence Micro-Resistance Measuring", Strojarstvo, vol.52, br. 3, str. 261-270, 2010. [Online]. Dostupno na: https://hrcak.srce.hr/64343. [Citirano: 14.11.2019.]

Sažetak
The micro-resistance measuring principle with specific forms of current
distribution in the plated through-hole of printed circuit board (PCB) is analyzed in this paper. Special attention is paid to the following factors that influence the micro-resistance measuring: the hole diameter, the type of the measuring probe and the PCB thickness, and their two and three-factor interactions. The experiment with three repetition of measurement is carried out for which the dispersion analysis includes: the calculated values of the sum of the square of deviation, the mean of the square of deviation and a comparison between the calculated factors and the relevant factor given for five percent α-risk. The results of the dispersion analysis clearly indicate that the strongest factor that influences the micro-resistance measures is the PCB thickness. The overall
conclusion is that the effect of each considered factor to the micro-resistance measures is expressive, but the effect of their mutual interactions is not significant in the measuring practice.

Ključne riječi
Dispersion analysis; Micro-resistance measuring method; Plated-through hole; Thickness measuring

Hrčak ID: 64343

URI
https://hrcak.srce.hr/64343

[hrvatski]

Posjeta: 703 *