Stručni rad

Analyses and solutions on technical and economical aspects of rapid prototyping technology

Jozef Novak-Marcincin ; Faculty of Manufacturing Technologies of Technical University of Kosice with a seat in Presov, Bayerova 1, 080 01 Prešov, Slovak Republic
Jozef Barna ; Faculty of Manufacturing Technologies of Technical University of Kosice with a seat in Presov, Bayerova 1, 080 01 Prešov, Slovak Republic
Ludmila Novakova-Marcincinova ; Faculty of Manufacturing Technologies of Technical University of Kosice with a seat in Presov, Bayerova 1, 080 01 Prešov, Slovak Republic
Veronika Fecova ; Faculty of Manufacturing Technologies of Technical University of Kosice with a seat in Presov, Bayerova 1, 080 01 Prešov, Slovak Republic

Sažetak

This article deals with basic characteristics and problems in the area of technology of Rapid Prototyping using layered manufacturing technology. It belongs to progressive methods of model creation based on geometry obtained from CAD environment with application possibilities in different industrial spheres. Chapters are focused on optimization of Rapid Prototyping preparation process. There is also an algorithm that leads to the selection of suitable settings. Utilization of the algorithm is explained on a case of printing with the use of UPrint device and Catalyst software, a system created for the utilization of Fused Deposition Modelling technology. There are outputs in the form of graphs and tables accumulating information directly affecting economical aspects of printing. Conclusion brings ideas on possible further progress in this area that would include a solution for the generation of database with stored information about previous printing results.

Ključne riječi

rapid prototyping; 3D print; algorithm; economical aspect

Hrčak ID:

75417

URI

https://hrcak.srce.hr/75417

Datum izdavanja:

27.12.2011.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.969 *