Prethodno priopćenje

Comparison of mechanical properties of surface layers with use of nanoindentation and microindentation tests

M. Zeleňák ; Institute of Physics, Faculty of Mining and Geology, VŠB -Technical University of Ostrava, Czech Republic
J. Valíček ; Institute of Physics, Faculty of Mining and Geology, VŠB -Technical University of Ostrava, Czech Republic
S. Hloch ; Faculty of Manufacturing Technologies of Technical University of Košice with a seat in Prešov, Slovak Republic
D. Kozak ; Mechanical Engineering Faculty in Slavonski Brod, University of Osijek, Slavonski Brod, Croatia
I. Samardžić ; Mechanical Engineering Faculty in Slavonski Brod, University of Osijek, Slavonski Brod, Croatia
M. Harničárová ; Nanotechnology Centre VŠB – Technical University of Ostrava, Ostrava – Poruba, Czech Republic
J. Klich ; Institute of Geonics of the AS CR, Ostrava-Poruba, Czech Republic
P. Hlaváček ; Institute of Physics, Faculty of Mining and Geology, VŠB -Technical University of Ostrava, Czech Republic
R. Cincio ; Faculty of Mechanical Engineering, Koszalin University of Techology, Koszalin, Poland

Sažetak

The objective of the paper is a mutual comparison of different methods for evaluation of mechanical properties of surface layers. Mechanical properties were tested with the use of nanoindentation and microindentation tests. Different loads and constant deformation speed were used in both cases. For the evaluation of mechanical properties, the AISI 304 type Chromium-Nickel steel commonly used in mechanical engineering industry was tested. Knowledge of relations and differences between nano and micromechanical properties is necessary for understanding of mechanical processes continuously occurring in surface layers during cutting processes.

Ključne riječi

nanohardness; microhardnesss; abrasive water jet; Chromium-Nickel steel

Hrčak ID:

80849

URI

https://hrcak.srce.hr/80849

Datum izdavanja:

1.7.2012.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.459 *