Tehnički vjesnik, Vol. 19 No. 3, 2012.
Izvorni znanstveni članak
Comparison of surface roughness quality created by abrasive water jet and CO2 laser beam cutting
Michal Zeleňák
; Institute of Geonics of the ASCR, v.v.i., Institute of Clean Technologies for Mining and Utilization of Raw Materials for Energy Use, Studentská 1768, 708 00 Ostrava - Poruba, Czech Republic
Jan Valíček
; Institute of Geonics of the ASCR, v.v.i., Institute of Clean Technologies for Mining and Utilization of Raw Materials for Energy Use, Studentská 1768, 708 00 Ostrava - Poruba, Czech Republic
Jiří Klich
; Institute of Geonics of the ASCR, v.v.i., Institute of Clean Technologies for Mining and Utilization of Raw Materials for Energy Use, Studentská 1768, 708 00 Ostrava - Poruba, Czech Republic
Petra Židková
; Department of Production Machines and Design, VŠB – Technical university of Ostrava, 17. Listopadu 15, 708 33 Ostrava-Poruba, Czech Republic
Sažetak
This paper deals with an evaluation of the surface roughness quality created by abrasive water jet and by CO2 laser, in terms of influence of the selected technological parameters on the final quality of machined surfaces. The main objective of these experimental studies was to consider the use of both technologies for cutting of difficult to cut materials. Experiments presented in the paper were carried out on titanium ASTM B265-99 samples. The machined surfaces of samples were measured by an optical profilometer. Subsequently, selected topographical characteristics were studied. The obtained data were used for comparison of surface roughness parameters Ra in different depths. Based on achieved results the comparison of both technologies was made.
Ključne riječi
abrasive waterjet cutting; CO2 laser beam cutting; optical profilometry; titanium sample
Hrčak ID:
86718
URI
Datum izdavanja:
19.9.2012.
Posjeta: 5.527 *