Skoči na glavni sadržaj

Prethodno priopćenje

Influence of material and gear parameters on the safety of gearing in metallurgical industry

S. Medvecká - Beňová ; Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia
I. Virgala ; Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia
M. Kelemen ; Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia
L'. Miková ; Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia


Puni tekst: engleski pdf 252 Kb

str. 224-226

preuzimanja: 1.957

citiraj


Sažetak

This paper deals with the appropriate choice of parameters to obtain the desired level of safety of gears in a gearbox to drive the conveyor in the metallurgical industry under increased load. Steel with surface hardness up to 350 HBW, or heat treated steel with hardness of 500 - 650 HBW are used. As a final heat treatment are used surface hardening, cementation and hardening, nitridation. Good properties of heat-treated steels are at the correct thickness of the heat-treated layer of the tooth. Results are presented for dual-ratio gearbox with spur gears from operation of an integrated steel company.

Ključne riječi

steel; material; heat treatment; gearing; safety factor

Hrčak ID:

126739

URI

https://hrcak.srce.hr/126739

Datum izdavanja:

1.1.2015.

Posjeta: 2.790 *