Skoči na glavni sadržaj

Izvorni znanstveni članak

The BTEX emission from moulding sands with furan resin dependence on the VOC content and loss on ignition

S. Żymankowska-Kumon ; AGH University of Science and Technology, Kraków, Poland


Puni tekst: engleski pdf 201 Kb

str. 607-610

preuzimanja: 781

citiraj


Sažetak

The article contains the results of emission BTEX (benzene, toluene, ethylobenzene and xylenes) during thermal destruction (500 – 1 300 °C) of moulding sand with furan resin. This furan resin is with a high content of free furfuryl alcohol (about 80 %). Knowledge of emissions of these compounds allows the assessment the harmfulness of a given moulding sand. Quantitative analysis of BTEX is highly complex and requires using of modern equipment (e.g. gas chromatography – mass spectrometry). Therefore, an attempt to assess potential emissions of BTEX compounds from a given moulding sand based on measurements of total volatile organic compounds (VOC) emission and loss on ignition (LOI). These measurements are less time-consuming and do not require expensive equipment.

Ključne riječi

castings; furan resin; moulding sand; BTEX; VOC

Hrčak ID:

138052

URI

https://hrcak.srce.hr/138052

Datum izdavanja:

1.10.2015.

Posjeta: 1.322 *