Metalurgija, Vol. 55 No. 1, 2016.
Prethodno priopćenje
Determination of bond strength between the hard-faced (HF) layer and the base material (BM) of forging dies
V. Lazić
; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
A. Sedmak
; Faculty of Mechanical Engineering, University of Belgrade, Belgrade, Serbia
I. Samardžić
; Faculty of Mechanical Engineering, University of Osijek, Slavonski Brod, Croatia
S. Aleksandrović
; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
D. Milosavljević
; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
D. Arsić
; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
M. Đorđević
; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
Sažetak
This paper points out complex working conditions of forging dies, which are the most frequent causes of their damage, and proposes suitable hard-facing repair procedures. The shear strength between the hard-faced layer and base metal has been measured using specially developed tool, and correlation between output results and the applied hard-facing technology is established.
Ključne riječi
forging dies; alloy steel; hard-facing; hardness; microstructure
Hrčak ID:
141844
URI
Datum izdavanja:
1.1.2016.
Posjeta: 1.408 *