Prethodno priopćenje

Friction stir welding (FSW) of aluminium foam sandwich panels

M. Bušić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Z. Kožuh ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
D. Klobčar ; Faculty of Mechanical Engineering, University of Ljubljana, Ljubljana, Slovenia
I. Samardžić ; Mechanical Engineering Faculty, University of Osijek, Slavonski Brod, Croatia

Sažetak

The article focuses on the influence of welding speed and tool tilt angle upon the mechanical properties at the friction stir welding of aluminium foam sandwich panels. Double side welding was used for producing butt welds of aluminium sandwich panels applying insertion of extruded aluminium profile. Such insertion provided lower pressure of the tool upon the aluminium panels, providing also sufficient volume of the material required for the weldment formation. Ultimate tensile strength and flexural strength for three-point bending test have been determined for samples taken from the welded joints. Results have confirmed anticipated effects of independent variables.

Ključne riječi

friction stir welding; aluminium foam; welding speed; sandwich panels; tool tilt angle

Hrčak ID:

153688

URI

https://hrcak.srce.hr/153688

Datum izdavanja:

1.7.2016.

Posjeta: 2.448 *