Izvorni znanstveni članak

Effect of process parameters on the end-face quality of cross-wedge rolling (CWR) shaft from titanium alloy Ti6Al4V

B. S. Sun ; Faculty of Mechanical Engineering & Mechanics, Ningbo University, Ningbo, China
Z. L. Zhao ; Faculty of Mechanical Engineering & Mechanics, Ningbo University, Ningbo, China
C. W. Wang ; Faculty of Mechanical Engineering & Mechanics, Ningbo University, Ningbo, China

Sažetak

In order to verify the formability of CWR of titanium alloy Ti6Al4V, and to study effect of parameters on the end-face quality of CWR shafts from titanium alloy Ti6Al4V. The forming process was simulated with the DEFORM-3D software．The results show that the concavity increase with the increase of length and the diameter of billet; they decrease with the increase of spreading angle; they increase firstly and then decrease with the increase of area reduction; they decrease firstly and then increase slowly with the increase of forming angle. Also the order of the influence degree of the five parameters in descending order is: diameter of billet, length of billet, area reduction, spreading angle and forming angle. And the simulation results were verified by experiments.

Ključne riječi

titanium alloy Ti6Al4V; cross-wedge rolling; shaft; process parameters; concavity

Hrčak ID:

206514

URI

https://hrcak.srce.hr/206514

Datum izdavanja:

1.1.2019.

Posjeta: 1.348 *