Izvorni znanstveni članak

https://doi.org/10.17559/TV-20181220075328

Evaluation of Cutting Parameters by Determination of the Grey Correlation Analysis Methods of the Effects on the Cutting Force and Surface Roughness of Duplex Stainless Steels (2205)

Ahmet Mavi ; Gazi University, OSTIM Vocational College, Department of Mechatronics, Ankara, Turkey (06500)

Sažetak

In this study, the effects of coated (TiAlN and TiN) drills and cutting parameters on drilling performance were investigated. Drilling operations were carried out by drilling holes 20 mm deep with 5 mm diameter drills on duplex stainless steel (2205). Three different cutting speeds (15, 20 and 25 m/min) and three different feed rates (0.05, 0.075 and 0.1 mm/min) were used in the experiments. The effects of different drills and cutting parameters on the cutting force and surface roughness are measured. Experiments were made in full factorial and optimum conditions were determined for the values measured by the gray relational analysis method. According to the gray correlation analysis value, it was found that the feed rates on the cutting force and surface roughness had a greater effect than the other factors. In addition, variance analysis (ANOVA) was performed to determine the effects of cutting parameters on cutting force (Fc) and surface roughness (Ra). According to ANOVA results, it is determined that the most effective parameter on Ra is the feed rate and the most effective parameter on the second degree is the cutting speed.

Ključne riječi

cutting force; drilling; duplex stainless steel (2205); gray relational analysis; surface roughness

Hrčak ID:

234236

URI

https://hrcak.srce.hr/234236

Datum izdavanja:

15.2.2020.

Posjeta: 1.883 *