Prethodno priopćenje

Development of a method for calculating the degree of use of the plasticity resource (DUPR) when rolling on a new continuous mill

M. M. Azilkiyasheva ; Almaty University of Power Engineering and Telecommunications, Almaty, Kazakhstan
S. B. Shayakhmetov ; Kazakh Academy of Transport and Communications named after M. Tynyshpayev, Almaty, Kazakhstan
G. B. Bakyt ; Kazakh Academy of Transport and Communications named after M. Tynyshpayev, Almaty, Kazakhstan
B. T. Kopenov ; Kazakh Academy of Transport and Communications named after M. Tynyshpayev, Almaty, Kazakhstan
G. A. Smailova ; Kazakh National Agrarian Research University, Almaty, Kazakhstan
Y. Y. Baubekov ; Kazakh Academy of Transport and Communications named after M. Tynyshpayev, Almaty, Kazakhstan
A. Zhauyt ; Almaty University of Power Engineering and Telecommunications, Almaty, Kazakhstan

Sažetak

A new design of a continuous mill is proposed in the article. A method has been developed for calculating the degree of use of the plasticity resource when rolling thin slabs on a new continuous mill using the data obtained in the MSC Super Forge environment. To determine the stress-strain state, it used measurement data in 5 stands. When rolling in the proposed mill steel D16 there is no violation of the continuity of the strip material. This is proved by calculation in the MSC Super Forge environment using the distribution of DUPR over the cross section of strips when rolling in a mill of a new design.

Ključne riječi

rolling; steel; strip; plasticity; stress-strain

Hrčak ID:

256109

URI

https://hrcak.srce.hr/256109

Datum izdavanja:

1.7.2021.

Posjeta: 552 *