Izvorni znanstveni članak
https://doi.org/10.1080/00051144.2021.1949532
Noise and sensitivity comparison for different BP filter designs
Zoran Šverko
; Faculty of Engineering, Department of Automatics and Electronics, University of Rijeka, Rijeka, Croatia
Nino Stojković
; Faculty of Engineering, Department of Automatics and Electronics, University of Rijeka, Rijeka, Croatia
Saša Vlahinić
; Faculty of Engineering, Department of Automatics and Electronics, University of Rijeka, Rijeka, Croatia
Ivan Markovinović
; Faculty of Engineering, Department of Automatics and Electronics, University of Rijeka, Rijeka, Croatia
Sažetak
In this paper, the analysis of noise and sensitivity for different BP filter designs is observed. Calculation of the voltage noise spectral density, root mean square (RMS) value of the noise voltage, Schoeffler sensitivity and the multi-parameter sensitivity is done for the simply designed (SD) active RC, noise and sensitivity optimized (NO and SO) active RC, operational transconductance amplifiers (OTA-C) and switched capacitor (SC) filter designs. This is observed for the fourth-order Chebyshev band-pass filter, with central frequency fc = 4 kHz, bandwidth 1 kHz and pass-band ripple αmax = −0.1 dB. Cascade of two second-order sections is used for fulfilment realization of all four observing designs. Programming tools, such as MATLAB and SPICE (LTspice), are also used for the analyses.
Highlights
• We used three different designs and optimization (noise and sensitivity) procedure for design and optimize the fourth-order Chebyshev band-pass filter
• Our results suggest which design is best to use for improving noise and sensitivity of this filter
• MATLAB and SPICE software were used for calculations and simulations of different band-pass filter designs and analysis of noise and sensitivity
Ključne riječi
Band-pass filter; noise; sensitivity; SC filter; design
Hrčak ID:
269846
URI
Datum izdavanja:
20.10.2021.
Posjeta: 435 *