Tehnički vjesnik, Vol. 31 No. 4, 2024.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20231226001235
Modelling of Flank and Crater Wear during Dry Turning of AISI 316L Stainless Steel as a Function of Tool Geometry Using the Response Surface Design
Djordje Vukelic
; University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Katica Simunovic
; University of Slavonski Brod, Mechanical Engineering Faculty, Trg Ivane Brlic Mazuranic 2, 35000 Slavonski Brod, Croatia
Vitalii Ivanov
; Sumy State University, Faculty of Technical Systems and Energy Efficient Technologies, Rymskogo-Korsakova 2, 40007 Sumy, Ukraine
Mario Sokac
; University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Vladimir Kocovic
; University of Kragujevac, Faculty of Engineering, Sestre Janjic 6, 34000 Kragujevac, Serbia
Zeljko Santosi
; University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Goran Simunovic
; University of Slavonski Brod, Mechanical Engineering Faculty, Trg Ivane Brlic Mazuranic 2, 35000 Slavonski Brod, Croatia
Sažetak
The article investigates the influence of geometric parameters of CVD cutting inserts on flank and crater wear during dry turning. Turning of AISI 316L stainless steel was performed with different values of approach angles, rake angles, clearance angles, inclination angles and corner radii. After dry turning, the flank and crater wear of the cutting inserts were measured. The effects of the input parameters on the output parameters were evaluated using ANOVA. The results of the experiments showed that the flank and crater wear increases with increasing approach angle, rake angle, clearance angle, inclination angle and decreasing corner radius. Based on the test results, statistical models were developed to predict the distribution of flank and crater wear using the response surface design. The absolute and percentage errors obtained show that the models developed can be successfully used to predict flank and crater wear.
Ključne riječi
crater wear; dry turning; flank wear
Hrčak ID:
318499
URI
Datum izdavanja:
27.6.2024.
Posjeta: 0 *