Metalurgija, Vol. 52 No. 1, 2013.
Prethodno priopćenje
The influence of drawing parameters on the properties high-manganese TWIP steel wires
Z. Muskalski
; Czestochowa University of Technology, Czestochowa, Poland
S. Wiewiórowska
; Czestochowa University of Technology, Czestochowa, Poland
M. Pełka
; Czestochowa University of Technology, Czestochowa, Poland
Sažetak
The paper presents an experimental analysis of the effect of single draft magnitude in the multi-stage drawing process on the mechanical properties of the wire, and a theoretical process analysis aimed at identifying the causes of the variations in mechanical properties, made using Drawing 2D, a FEM-relying software program of high manganese TWIP steel rolling and stamping processes. It was found that wires drawn with small partial drafts (Gp%=11 %) had a larger plasticity reserve, as defined by the R0.2/Rm ratio, as compared with wires drawn with large partial drafts (Gp = 26 %). A drop both in tensile strength Rm and in proof stress R0.2 was also found to occur after a total draft of Gc = 80 % had been exceeded, which was caused by the “strain softening” phenomenon.
Ključne riječi
drawing; properties; TWIP steel; wire
Hrčak ID:
86776
URI
Datum izdavanja:
1.1.2013.
Posjeta: 1.231 *