Tehnički vjesnik, Vol. 23 No. 1, 2016.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20151028072528
The effect of the teeth profile shape on polymer gear pair properties
Jože Duhovnik
; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Damijan Zorko
; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Luka Sedej
; Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Sažetak
The paper presents an extensive research on two different tooth-flank geometries, i.e. involute and S-gears. A significant difference between the two analyzed geometries was observed during the lifetime testing. The tests were conducted on special test equipment with an axis distance of 20 mm. The material used for the tested gears was POM for the driver gear and PA6 for the driven gear. The same sizes of driver and driven gears were used (m = 1 mm, z = 20). Gears of this size are particularly suitable for micro-gear transmissions. The tests were carried out using different rotational speeds and torques, between 0,8 N·m and 1,5 N·m. During testing the thermal state of the gears was measured with a thermal camera. The stress and deformation analyses of the tested gears were undertaken using numerical simulations employing the finite-element method.
Ključne riječi
failure; involute gears; polymer; S-gears; temperature
Hrčak ID:
153172
URI
Datum izdavanja:
19.2.2016.
Posjeta: 3.714 *