Tehnički vjesnik, Vol. 23 No. 4, 2016.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20141201225004
Prediction of technological parameters of sheet metal bending in two stages using feed forward neural network
Jernej Senveter
orcid.org/0000-0002-5581-7726
; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Joze Balic
; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Mirko Ficko
; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Simon Klancnik
; University of Maribor, Faculty of Mechanical Engineering, Smetanova ulica 17, 2000 Maribor, Slovenia
Sažetak
This paper describes sheet metal bending in two stages as well as predicting and testing of the final bend angle by means of a feed-forward neural network. The primary objective was to research the technological parameters of bending sheet metal in two stages and to develop an intelligent method that would enable the predicting of those technological parameters. The process of bending sheet metal in two stages is presented by demonstrating the various technological parameters and the test tool used to carry out tests and measurements. The results of the tests and measurements were of decisive guidance in the evaluation of individual technological parameters. Developed method for prediction of the final bend angle is based on a feed-forward neural network that receives signals at the input level. These signals then travel through the hidden level to the output level, where the responses to input signals are received. The input to the neural network is composed of data that affect the selection of the final bend angle. Only five different inputs are used for the total neural network. By choosing the desired final bend angle by means of the trained neural network, bending sheet metal in two stages is optimised and made more efficient.
Ključne riječi
bending in two stages; intelligent system; neural network; prediction of the final bend angle
Hrčak ID:
163794
URI
Datum izdavanja:
16.8.2016.
Posjeta: 2.557 *