Metalurgija, Vol. 56 No. 1-2, 2017.
Prethodno priopćenje
The influence of applied heat-treatment on in 718 fatigue life at three point flexural bending
J. Belan
; University of Žilina, Faculty of Mechanical Engineering, Žilina, Slovakia
L. Kuchariková
; University of Žilina, Faculty of Mechanical Engineering, Žilina, Slovakia
E. Tillová
; University of Žilina, Faculty of Mechanical Engineering, Žilina, Slovakia
A. Vaško
; University of Žilina, Faculty of Mechanical Engineering, Žilina, Slovakia
Sažetak
The Inconel alloy 718 is an iron-nickel based superalloy with a working temperature up to 650 °C. Presented phases such as γ'' (Ni3Nb), γ' (Ni3Al), and δ (delta – Ni3Nb) are responsible for the alloy's unique properties. The δ – delta phase is profitable when situated at grain boundaries in small quantities due to increasing fatigue life. However, at temperatures close to 650 °C the γ'' transforms to δ – delta and causes a decrease in fatigue life. Heat-treatment (800°C/ for 72 hours) and its influence on fatigue life are discussed in this paper. Fatigue tests were carried out at room temperature. After the tests we plotted the S-N curves for both stages. SEM (Scanning Electron Microscopy) fractography was carried out as well.
Ključne riječi
IN 718 alloy; heat-treatment; fatigue test; S-N curve; SEM fractography
Hrčak ID:
168922
URI
Datum izdavanja:
2.1.2017.
Posjeta: 1.409 *