Izvorni znanstveni članak

https://doi.org/10.17559/TV-20240325001430

The Influence of the Number of Layers and the Raster Angle on the Mechanical Properties of 3D Printed Materials

Strahinja Đurović ; Faculty of Technical Sciences, University of Priština, Kneza Miloša 7, 38220 Kosovska Mitrovica
Dragan Lazarević orcid.org/0000-0001-5110-6620 ; Faculty of Technical Sciences, University of Priština, Kneza Miloša 7, 38220 Kosovska Mitrovica *
Vladimir Milovanović ; Faculty of Engineering, University of Kragujevac, Sestre Janjić 6, 34000 Kragujevac, Serbia
Milan Mišić ; Kosovo and Metohija academy of applied studies, Higher Technical School of Professional Studies Zvecan, Dositeja Obradovića bb, 38218 Leposavić
Živče Šarkoćević ; Faculty of Technical Sciences, University of Priština, Kneza Miloša 7, 38220 Kosovska Mitrovica

* Dopisni autor.

Sažetak

3D printing represents one of the newer production technologies which are becoming more and more important. The widening range of materials used in 3D printing leads to the need to examine their mechanical properties. 3D printing parameters such as infill pattern, building orientation, layer thickness, number of layers in the wall and air gap have a great influence on the mechanical properties. In this study, the mechanical properties were examined from the perspective of the influence of the raster angle and the change in the number of layers in the wall. Three different materials were tested, PLA, PETG and ABS. The results showed that the highest tensile strength was obtained with PETG material, and the lowest with ABS. From the aspect of the influence of the printing parameters, we can conclude that the building orientation and the number of layers in the wall have influence on mechanical properties of the material.

Ključne riječi

3D printing; mechanical properties; raster angle; tensile strength; wall layers

Hrčak ID:

321910

URI

https://hrcak.srce.hr/321910

Datum izdavanja:

31.10.2024.

Posjeta: 162 *