Metalurgija, Vol. 53 No. 2, 2014.
Prethodno priopćenje
The influence of mixing water and abrasives on the quality of machined surface
A. Stoić
; Faculty of Mechanical Engineering in Slavonski Brod, Slavonski Brod, Croatia
M. Duspara
; Faculty of Mechanical Engineering in Slavonski Brod, Slavonski Brod, Croatia
B. Kosec
; Faculty of Natural Sciences and Engineering, University of Ljubljana, Ljubljana, Slovenia
M. Stoić
; University of Applied Sciences, Slavonski Brod, Croatia
I. Samardžić
; Faculty of Mechanical Engineering in Slavonski Brod, Slavonski Brod, Croatia
Sažetak
This paper shows the impact of mixing water and abrasives in water jet cutting process on the quality of the machined surface. The tests were done with polymer material SIPAS, where the influence of cutting parameters was researched (cutting pressure, cutting feed and abrasive mass flow). The surface roughness was measured on several zones, regarding the depth of materials, because the roughness is increased with the material thickness.
Ključne riječi
mixing; abrasives; nozzle; water jet
Hrčak ID:
110276
URI
Datum izdavanja:
1.4.2014.
Posjeta: 1.497 *