Skoči na glavni sadržaj

Tehnički vjesnik, Vol. 28 No. 3, 2021.

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20201102100726

The Influence of Surface Roughness on Laser Beam Welding of Aluminium Alloys

Michaela Lopatková ; Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Paulínska 16, 917 24 Trnava, Slovakia
Jozef Bárta* orcid id orcid.org/0000-0003-0607-4433 ; Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Paulínska 16, 917 24 Trnava, Slovakia
Milan Marônek orcid id orcid.org/0000-0002-4716-8092 ; Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Paulínska 16, 917 24 Trnava, Slovakia
Filip Šugra ; Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Paulínska 16, 917 24 Trnava, Slovakia
Michela Kritikos orcid id orcid.org/0000-0001-5406-3953 ; Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Paulínska 16, 917 24 Trnava, Slovakia
Ivan Samardžić ; Mechanical Engineering Faculty in Slavonski Brod, University of Slavonski Brod, Trg I.B. Mažuranić 2, Slavonski Brod, Croatia
Dejan Marić ; Mechanical Engineering Faculty in Slavonski Brod, University of Slavonski Brod, Trg I.B. Mažuranić 2, Slavonski Brod, Croatia

Puni tekst: engleski pdf 1.900 Kb

str. 934-938

preuzimanja: 1.145

citiraj

Sažetak

A laser beam is the light that is subject to the laws of physics. Surface roughness can cause that the light can be reflected in different angles. Therefore, the surface roughness may influence the amount of light to be reflected so the power of the laser could be lowered. Present paper analyses the influence of different surface roughness on porosity and geometry of weld joint using design of experiment. Surface roughness monitored during the experiment was in the range from Ra 0.8 to Ra 15 achieved and by machining on aluminium-lithium alloy AW2099. In order to keep the same condition for welding the bead on plate welds were realised. Porosity was analysed using computer tomography. Surface roughness proved to have minor influence on porosity as well as the shape of the weld joint.

Ključne riječi

computed tomography; laser beam welding; porosity; surface roughness

Hrčak ID:

258225

URI

https://hrcak.srce.hr/258225

Datum izdavanja:

6.6.2021.

Posjeta: 1.930 *