Izvorni znanstveni članak

https://doi.org/10.5552/drvind.2022.2040

Modelling and Investigating Real-World Drying Defects in Wood

Darius Albrektas ; Kaunas University of Applied Sciences, Faculty of Technology, Kaunas, Lithuania
Agne Styraite ; Kaunas University of Technology, Faculty of Mechanical Engineering and Design, Kaunas, Lithuania

Sažetak

Depending upon the conditions in which they are used, wood products are required to have been produced with the necessary moisture levels for the intended job. In many cases, this means that drying is required in order to achieve these moisture levels. Wood is also often thermally modified. During the required processing, stresses often occur in wood assortments. If such stresses exceed the limits of durability in the wood, cracks will appear. Similar cracks in wood can occur prior to the drying and/or heat treatment stage. These defects are usually internal and invisible, but they can significantly alter the mechanical properties of the product. This study has shown that wood defects can often be detected using the original method, which involved transverse resonant vibrations, invisible drying, and others. It has been found that a defect of at least 12.5 % of the specimen’s overall length will change the mechanical properties of that specimen. When the defect length makes 25 % of the specimen’s overall length, or even more, the assortment sometimes behaves as a system of several bodies. In addition, when the defect reaches half the total length of the specimen, the modulus of elasticity may decrease to 20 %, and the coefficient of damping may increase to 80 %.

Ključne riječi

wood moisture content; drying defects; resonant frequency; amplitude characteristics; transverse vibrations; modulus of elasticity; coefficient of damping

Hrčak ID:

278435

URI

https://hrcak.srce.hr/278435

Datum izdavanja:

31.5.2022.

Podaci na drugim jezicima: hrvatski

Posjeta: 751 *