Tehnički vjesnik, Vol. 29 No. 5, 2022.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20210913080305
Analysis of Contact Surface Wear Performance of O-Ring Dynamic Seal Based on Archard Model
Yan Zhao
; School of Mechanical Science and Engineering, Northeast Petroleum University, Daqing high-tech development zone university street No. 99, Daqing, Heilongjiang Province, China
Ziming Feng
; College of Mechanical and Electrical Engineering, Wenzhou University, Chashan Higher Education Park, Ouhai District, Wenzhou City, 325000, China
Yunchao Li
; National Pipeline Group Northern Pipeline Co., Ltd., No. 408, Xinkai Road, Guangyang District, Langfang, Hebei, China
Li Feng
; Research Institute of Oil Production Engineering, Daqing Oilfield Co. LTD, China
Qi Li
; Research Institute of Oil Production Engineering, Daqing Oilfield Co. LTD, China
Wei Cui
; Northeast Petroleum University, Daqing high-tech development zone university street No. 99, Daqing, Heilongjiang, China
Sažetak
With the development of hydraulic system to high pressure gradually, the leakage risk of sealing system increases, and it is necessary to confirm the performance parameters of sealing structure through analysis and calculation. The traditional analysis of the friction and wear performance of the seal ring is limited to the amount of wear, and cannot describe the surface wear characteristics of the O-ring in detail. Based on the Archard model, this paper constructs a model to analyse and calculate the friction and wear performance of the dynamic seal structure through the material characteristics and operating parameters, analyses the friction and wear characteristics of the O-ring seal structure under different compression ratio, medium pressure, relative slip velocity and temperature, and summarizes the influence of each single variable on the wear characteristics of the dynamic seal structure. According to the analysis in this paper, the increase of medium pressure of 5 MPa will cause the wear concentration area of the contact surface to move to the back pressure side, and the overall wear will be reduced, but the increase of contact area will lead to the weakening of sealing effect. By the action of 15 MPa, when the compression ratio is between 5% and 10%, the change of cumulative wear rate and the wear rate of each node is small.
Ključne riječi
archard model; dynamic seal; hydraulic seal; O-ring seal; wear
Hrčak ID:
281654
URI
Datum izdavanja:
15.10.2022.
Posjeta: 1.129 *