Original scientific paper

The drying kinetics of protective coatings used on sand molds

Ł. Jamrozowicz ; AGH University of Science and Technology, Faculty of Foundry Engineering, Kraków, Poland
J. Zych ; AGH University of Science and Technology, Faculty of Foundry Engineering, Kraków, Poland
J. Kolczyk ; AGH University of Science and Technology, Faculty of Foundry Engineering, Kraków, Poland

Abstract

Investigation results of the drying rate of the selected protective coatings (water and alcohol) are presented in the article. Coating drying rate was determined for the first and second layers. The coating was applied to moulding sand cores. The rate of drying coatings were tested for three coating apparent viscosities estimated by means of the Ford 4 mm cup. Drying rates of the protective coating were examined by using the gravimetric technique and ultrasonic technique. Measurements were carried out in a continuous way under controlled conditions: constant ambient temperature and air humidity. Research shows that the drying time of the second coating layer is longer by 20 – 30 % than the first layer.

Keywords

foundry; molds; protective coatings; kinetics of drying; gravimetric technique; ultrasonic technique

Hrčak ID:

126665

URI

https://hrcak.srce.hr/126665

Publication date:

1.1.2015.

Visits: 1.996 *